TM 5-6115-596-14
b.
Position regulator to mounts (13) on inner frame (14).
c,
Position regulator ground lead (6) to regulator, and secure
lead and regulator to mounts with eight washers (8) and four screws
(5).
d.
Connect ground leads (4) to regulator with screw (3).
e.
Connect wiring harness (1) to regulator battery connector (2)
and regulator generator connector (12).
Generator Regulator Resilient Mounts (fig. 5-21).
5-33.
NOTE
The four resilient mounts are re-
moved and installed in a similar
manner.
Do not remove or install
more than one mount at a time.
a.
Removal.
(1) Make certain all power is turned OFF.
(2) Remove screws and three washers securing regulator to inner
frame.
-(3) Loosen three mount screws so that regulator can be moved to
either side.
(4) Remove two screws securing resilient mount to inner frame.
(5) Support regulator, and remove mount.
NOTE
The left reAr mount screw also
secures the regulator ground
lead.
Inspect resilient mounts for cracks,
Inspection and Repair.
b.
wear, and loss of resiliency.
Replace mounts that show any one of
these defects.
Change 2 5-51
