TM 5-6115-596-14
proper electrical characteristics.
Refer to figure 4-2 for electri-
cal schematic diagram of generator regulator and table 5-5 for cir-
cuit values of points on plug strip (PS) and connector block (CR).
5-31.
Assembly (fig. 5-20).
Position voltage regulator assembly (.22) to base plate (21)
a.
and secure with bolt (24) and washer (23).
Position relay assembly (6) to base plate and secure with six
b.
screws (7).
c.
Install two new gaskets (26) and cable assemblies (16) in
regulator case (13) and secure with eight screws (17).
d.
Position two bus bars (11) inside case and secure with four
screws (12).
e.
Position new gasket (25) and base plate with regulator and re-
lay assemblies to case and secure with six lockwashers (18), screws
(19), and new wire seal (20).
f.
Position clamp (30) with cable assemblies (,16) to regulator
and relay assemblies and secure with flat washer (29), lockwasher
(28), screw (27).
Connect bus bars to relay with flat washers (10), lockwashers
g.
(9), and nuts (8).
h.
Position new gasket (5) and cover (1) to case and secure with
six lockwashers (4), screws (3), and new wire seal (2).
Installation (fig. 5-19 or 5-19.1).
5-32.
a.
If new generator regulator (9) is to be installed (generator
sets, serial numbers 923-001 thru 923-553), reinstall four brackets
(7) on new regulator.
al.
If new generator regulator (8) is to be installed (serial
numbers 929-001 thru 929-290), reinstall two brackets (7) on new
regulator.
Change 2
5-50
