TM 5-6115-332-14
P-8-614-14
TO 35C2-3-424-1
1. Screw
2. Lockwasher
3. Clip
4. Screw
5. Lockwasher
6. Wiring harness
7. Connector
8 . C l a m
p
9. Adapter
10. Clamp
11. Sleeving
12. Grille
13. Eye bolt
Figure 7-8. Main generator stator and housing assembly, disassembly (Model MEP-017A).
(2) Model MEP-022A.
(a) Tag and disconnect all leads.
(b) Remove screws (1, fig. 7-9) and lock-
washers (2) and remove the wire clips (3) from the
exciter frame (27).
(c) Remove screws (4) and lockwashers (5)
and remove the generator wiring harness (6) from
the housing (28).
(d) Disassemble the wiring harness (6) by
removing connector (7) at clamp (8) and adapter (9)
at clamp (10) from the leads and sleeving (11).
(e) Remove the lifting eyebolt (12) and nut
(13) from the housing (28).
(f) Remove capscrews (14) and lockwashers
(15) and remove the generator housing adapter (16)
and air inlet grille (17) from the housing (28).
(g) Remove capscrews (18) and lock-
washers (19) and remove the stator (20).
(h) Remove capscrews (21) and lock-
washers (22) and remove the exciter frame assem-
bly (27) from the housing (28).
(i) Remove screws (23) and lockwashers
(24) and remove the exciter pole (25) and exciter
coil (26) from the exciter frame assembly (27).
7-14
