TM 5-6115-332-14
P-8-614-14
TO 35C2-3-424-1
e. Cleaning and Inspection.
(1) Clean the voltage regulator using a clean
lint free cloth.
(2) On old style regulators inspect saturable
reactor, filter reactor, stepdown transformer and
voltage regulator for cracks, breaks, evidence of
overheating or other damage.
f. Repair. Replace a damaged or defective voltage
regulator.
(2) Connect electrical connectors to the voltage
regulator.
(3) Position access panel in place on control
box and secure with washers and screws.
(4) Place voltage regulator (PN 13211E6975
(97403) or 13212E8950 (97403))in place in control
box and secure with washers and screws.
(5) Reconnect wiring.
(6) Position access cover in place on control
g. Installation.
box and secure with washers and screws.
(1) Place voltage regulator (PN 13219E0883
(97403)) in position in the control box and secure
with washers and screws.
Figure 7-4. Voltage regulator, removal and installation, PN 13219E0883 (97403).
7-7. Wiring and Wire Harness
an open circuit is indicated, replace the wire. Al-
a. General. All of the generator set wiring can
ways use a wire of at least equal size. Individual
be identified by identification numbers on the wire.
wires may be substituted for the defective wires in a
The wiring can be systematically checked by refer-
wiring harness by running a new wire along side
ence to the wiring diagrams (figs. FO-2 and FO-4).
the harness. Tape, lace, or use plastic wire straps to
b. Testing and Replacement. To test, discon-
secure the wire and make it an integral part of the
harness.
nect both ends of the wire under test. Touch the
probes of the multimeter to each end of the wire. If
Change 5
7 -
7
