TM 5-6115-275-14
NAVFAC P-8-615-14
TO 35C2-3-4521
Section III. REPAIR PARTS, SPECIAL TOOLS AND EQUIPMENT
4-6.
Tools and Equipment
Basic issue tools and equipment that are authorized
for performing maintenance on the generator set are
listed in Appendix B.
4-7.
Special Tools and Equipment
No special tools and equipment are required by
organizational maintenance personnel for performing
maintenance on the generator set.
4-8.
Organizational Maintenance Repair Parts
The organizational maintenance repair parts are
listed and illustrated in TM 5-6115-275-24P, or TO 35C2-
452-4.
Section IV. LUBRICATION INSTRUCTIONS
4-9.
General
a.
This section contains lubrication instructions
which are supplemental to and not specifically covered in
the lubrication order. For the current lubrication order,
refer to LO 5-2805-259-12.
b.
Carefully inspect the generator set to insure that
proper specifications have been met as required by the
lubrication order.
NOTE
Proper
preventive
maintenance
observation
and
adherence
will
prolong the life of the generator set.
4-10.
Detailed Lubrication Information
Refer to detailed lubrication information in paragraph
3-3.
4-11.
Air Cleaner Service (Models 4A084-2 and
4A084-3)
a.
Refer to figure 4-20 and service the air cleaner.
b.
Observe the service notes in the cleaning of the
air cleaner.
NOTE
Insure that the passages are not
obstructed and are free of dirt and
accumulative
materials
before
reassembly.
STEP 1.
LOOSEN HEAD CLAMP (2).
STEP 2.
REMOVE HEAD AND FILTER ELEMENT.
STEP 3.
CLEAN
HEAD
AND
BODY
WITH
CLEANING
SOLVENT
AND
DRY
THOROUGHLY.
NOTE:
WHEN
RESTRICTION
INDICATOR
SHOWS
FULLY
RED,
REMOVE
ELEMENT FROM BODY AND CLEAN
ELEMENT
WITH
LOW
PRESSURE
COMPRESSED AIR.
STEP 4.
REPLACE ELEMENT IN BODY AND
INSTALL HEAD.
STEP 5.
SECURE HEAD WITH CLAMP (2) AND
PRESS RESET BUTTON TO RESET
RESTRICTION INDICATOR.
Figure 4-20. Air cleaner service.
Change 2 4-23
