TM 5-6115-271-14
TO 35C2-3-386-1
TM-05926A-14
NAVFAC P-8-613-14
NOTE
resistor board, heat sink, and the necessary wiring
Although the interior of the generator sets
harness.
may differ slightly, the removal and the in-
stallation of the control box as illustrated
6-3. Control Box
in this figure, is essentially the same.
Refer to figure 6-3 to remove and install the control
box.
Section IV.
b. Installation.
6-4. Generator
(1) Refer to figure 6-1 and install the generator.
a. Removal.
(2) Install the control box (fig. 6-3).
(1) Remove the control box (fig. 6-3).
(2) Refer to figure 6-1 and remove the generator.
