TM 5-6115-405-15
CHAPTER 5
GENERAL MAINTENANCE INSTRUCTIONS
Section I. SPECIAL TOOLS AND EQUIPMENT
general support and depot maintenance personnel
5-1. Special Tools and Equipment
performing major overhaul work on the generator set.
Tools listed in table 5-1 are not available for issue, but
No special tools and equipment are required.
must be fabricated by qualified direct and general
support and depot maintenance personnel.
5-2. Specially Designed Tools and Equipment
The specially designed tools listed in table 5-1 and
illustrated in figures 5-1 through 5-7 are for direct and
Table 5-1. Specially Designed Tools
Reference
Item
Figure
Paragraph
Use
Rotor locking tool (23960)................
Hold magneto rotor when remov-
ing or installing rotor shaft
nut or generator rotor.
Offset wrench (24002) .....................
Remove and install cylinder nuts.
Needle bearing assembly tool..........
Remove and install needle bearing
(23756)
in connecting rod (piston end)'.
Bearing and seal tool (23757) ..........
Remove needle bearing and seal
from crankcase, remove and in-
stall needle bearing in stator
mounting plate, and install
needle bearing in crankcase.
Seal assembling plug (23758)..........
Install seal in crankcase.
Seal assembling sleeve (23759) ......
Protect seal when installing
crankshaft into crankcase.
Piston pin removal tool (23949) .......
Remove piston pin from piston.
5-1