TM 5-6115-329-14
TO 35C2-3-440-1
b. Cleaning. Clean the rectifiers using a clean
lint-free cloth and dry low pressure compressed air.
c. Inspection and Repair.Inspect rectifiers for
cracks, breaks, and for evidence of overheating. Re-
place defective rectifier(s) as required.
d. Installation.
(1) Install rectifier to mounting bracket with
nut.
(2) Reconnect leads.
(3) Refer to paragraph 9-7 d. and install
minal board assembly.
e. Test.
(1) Models MEP-019A and MEP-014A.
(a) Disconnect wires V9B16, X1B16,
Section VI.
9-9. Wiring and Wire Harness
a. General. All of the generator set wiring
ter-
and
V10B16, from the terminal board.
(b) Check the front-to-back resistance ratio
of each rectifier with an ohmeter. Ratio should be at
least 100,000/1 with the forward resistance being
10 ohms maximum.
(2) Model MEP-024A.
(a) Disconnect wires V9B14, X76B14,
X5B14, X4B14, X3B14, X2B14, and X1B14 from the
terminal board.
(b) Check the front-to-back resistance ratio
of each rectifier with an ohmeter. Ratio should be at
least 100,000/1 with the forward resistance being
10 ohms maximum.
WIRING HARNESS
ways use a wire of at least equal size. Individual
can
wires may be substituted for the defective wires in a
be identified by identification numbers on the wire.
wiring harness by running a new wire along side
b. Testing and Replacement. TO test, discon-
the harness. Tape, lace, or use plastic wire straps to
nect both ends of the wire under test. Touch the
secure the wire and make it an integral part of the
probes of the multimeter to each end of the wire. If
harness.
an open circuit is indicated, replace the wire. Al-
Section VII. SHOCK MOUNTS
9-10. Shock Mounts
structions to remove the shock mounts.
a. Removal.
(a) Drill out rivets securing the control
(1) Refer to paragraphs 4-22,4-23,4-25,4-27,
panel assembly shock mounts to the control panel.
4-29, 6-3, 9-6, 9-7, and 9-8 and remove the rheostat,
(b) Remove shock mounts.
voltmeter, load on/off switch, voltage control
(c) Remove shock mounts from the control
switch, terminal, load, control panel, voltage regu-
panel mounting bracket in the same manner.
later, terminal board assembly and rectifers.
(2) Refer to figure 9-5 and the following in-
9 - 8
