TS 6115-329-14/9-2
TM 5-6115-329-14
TO 36C2-3-440-1
Section III VOLTAGE REGULATOR
9-6. Voltage Regulator
a. Removal.
(1) Refer to paragraph 9-2 a. and remove con-
trol panel assembly.
(2) Refer to figure 9-2 and the following in-
structions to remove voltage regulator.
(a) Tag and disconnect leads from the volt-
age regulator.
(b) Remove nuts securing the voltage regu-
lator in the control box.
(c) Remove voltage regulator.
b. Cleaning. Clean the voltage regulator hous-
ing using a clean lint-free cloth.
c. Inspection and Repair. Inspect voltage reg-
ulator for cracked housing and for evidence of over-
heating. Replace defective voltage regulator.
d. Installation.
(1) Position voltage regulator in place in the
control box.
(2) Secure with nuts.
(3) Reconnect leads.
(4) Refer to paragraph
control panel assembly.
9-2 d. and install the
Figure 9-2. Voltage regulator, removal and installation.
Section IV. TERMINAL BOARD
9-7. Terminal Board Assembly
nal board assembly.
a. Removal. Refer to figure 9-3 and the follow-
(2) Remove screws securing
ing instructions to remove terminal board assem-
board to the control box assembly.
bly.
(3) Remove terminal board.
(1) Tag and disconnect leads from the termi-
the terminal
9 - 4
