TM 5-6115-329-14
TO 35C2-3-440-1
(6) Remove motor drive machine bolt (3).
(7) Remove nuts (4), bolts (5), and washers (6)
securing the generator housing and stator (7) to the
engine end bell and remove housing and stator.
(8) Remove bearing (8) from end of engine
shaft.
(9) Insert special tool (Table 5-1) into out-
board end of rotor and thread until rotor assembly
becomes free of shaft and remove rotor (9).
(10) Remove fan (10) from rotor.
(11) Remove bolts (11) securing engine end
bell (12) to engine housing and remove end bell.
b. Installation.
(1) Install engine end bell (12, fig. 6-4) to the
engine housing with bolts (11).
(2) Thread fan (10) onto rotor (9) and install
fan and rotor on engine shaft.
(3) Install bearing (8) on engine shaft.
(4) Position housing and stator (7) in place on
end bell and secure with washers (6), screws (5), and
nuts (4).
(5) Install motor drive machine bolt (3).
(6) Install end cap (2) to generator housing
with screws (1).
(7) Refer to figure 6-3 and install control
panel bracket and fuel tank bracket.
(8) Attach fuel line (fig. 4-30).
(9) Install control panel assembly (para 6-3).
(10) Secure engine-generator assembly in car-
rying frame by installing bolts into shock mounts.
6-6
