TM 5-6115-329-14
TO 35C2-3-440-1
CHAPTER 5
INTERMEDIATE (FIELD), (DIRECT AND GENERAL SUPPORT)
AND DEPOT MAINTENANCE INSTRUCTIONS
Section I.
REPAIR PARTS, SPECIAL TOOLS, TEST, MEASUREMENT AND
DIAGNOSTIC EQUIPMENT (TMDE) AND SUPPORT EQUIPMENT
5-1. Intermediate (Field), (Direct and
General Support) and Depot
Maintenance Repair Parts
a. Generator. Repair parts and equipment are
listed and illustrated in TM 5-6115-329-24P/TO
35C2-3-440-4.
b. Engine. Refer to TM 5-2805-256-24P/TO
38G2-102-4 for repair parts and equipment per-
taining to the MIL-STD engine Model 1A08-3.
5-2. Special Tools and Equipment
a. Generator. There are no special tools or
equipment needed by intermediate (field), (direct
and general support) or depot maintenance person-
nel for performing maintenance on the generator
set.
b. Engine. Refer to TM 5-2805-256-14/TO
38G2-102-2 for special tools and equipment needed
by intermediate (field), (direct and general support)
and depot maintenance personnel for performing
maintenance on the MIL-STD engine Model 1A08-3.
Table 5-1. Fabricated Tools and Equipment
Nomenclature
Reference No. or NSN
Material Required
Rotor puller
Unknown
Steel
Reference
Item
Paragraph
Use
Rotor puller
6-4
Pull rotor free of engine shaft.
5-3. Fabricated Tools and Equipment
or overhaul work on the generator set. Tools and
Generator. The specially designed tools and
equipment listed in Table 5-1 are not available for
equipment illustrated and listed in Table 5-1 are for
issue, but must be fabricated by qualified inter-
intermediate (field), (direct and general support)
mediate (field), (direct or general support) and
and depot maintenance personnel performing repair
depot maintenance personnel.
5-1
