TM 5-6115-323-14
4-27. Replace Lost or Broken Terminal Clip
(Retainer, Safety Clip)
The terminal clip is a component of both the load
terminal and the ground terminal. If the terminal clip
is lost or broken, fabricate as follows: Requisition bulk
wire as stated in the chart. Cut off about 3 inches of
the wire. Cut the wire short enough to keep the clips
from touching another terminal or the generator
frame in the open or closed position. Slip the wire
through the hole in the terminal and proceed as shown
in the views below:
NSN 9505-
1 MEP-015AI MEP-025A
00-804-3814
Load
Ground
(0.042 inch)
Ground
I
01-049-0144
I
I
Load
(0.050 inch)
BULK WIRE CHART
Change 5
4-25/(4-26 blank)
