Cleaning, Inspection and Repair.
Clean all parts in a well-ventilated
area. Avoid inhalation of solvent
fumes and prolonged exposure of
skin to cleaning solvent. Wash
cleaning solvent (Fed. Spec. P-D-680
and P-S-661) used to clean parts is
potentially dangerous to personnel
and property. Do not use near open
flame or excessive heat. Flash point
of solvent is 100°F (38°C).
Clean items with cleaning solvent, Fed.
Spec. P-D-680 or P-S-66 1, and dry thoroughly.
Inspect ground stud terminal for
stripped threads and other defects. Replace a damaged
or defective ground stud.
Installation. Refer to figure 4-82 and install
the ground stud terminal.
(Retainer, Safety Clip).
For fabrication procedures, see paragraph 4-60.
Slave Receptacle (Model MEP-023A)
Removal. Refer to figure 4-83 and remove
the slave receptacle.
Figure 4-83. Slave receptacle, removal and installation
(Model MEP- 023A).
Change 8 4-94