Figure 4-80. Air baffles, removal and installation (Model MEP-018A).
Cleaning, Inspection and Repair.
Clean all parts in a well-ventilated
area. Avoid inhalation of solvent
fumes and prolonged exposure of
skin to cleaning solvent. Wash
cleaning solvent (Fed. Spec. P-D-680
and P-S-661) used to clean parts is
potentially dangerous to personnel
and property. Do not use near open
flame or excessive heat. Flash point
of solvent is 100°F (38°C).
Clean baffles with cleaning solvent,
Fed. Spec. P-D-680 or P-S-66 1, and dry thoroughly.
Inspect for cracks, breaks or other
damage. Replace a defective baffle.
Install the air baffles as shown by
Install the control cabinet (fig. 4-79).
Install the battery (fig. 4-78).
Bracket, Guard Frame, and Vibration Mounts
Removal. Refer to figure 4-81 and remove
toolbox, brackets, mounts, and rail guard.
Change 8 4-91