TM 5-6115-596-14
(c) Two screws (13) and washers (14) securing drive belt
brace to engine, and brace.
Installation.
b.
(1) If replacement engine is to be installed, reinstall:
(a) Drive belt brace (15) to engine (11) with two washers (14)
and screws (13).
(b) Fuel filter with shutoff valve (par. 4-17).
(c) Fuel filter-to-fuel pump hose (par. 4-18).
(2) Position engine to inner frame (12) and secure with 12
washers (10) and 6 screws (9).
(3) Position bracket (21) to rear exhaust manifold (8), and
tighten screw (7).
(4) Install mufflers (par. 4-20).
(5) Loosely install drive belt brace to starter-generator (24)
with two washers (23)
and screw (22).
(6) Install and adjust starter-generator drive belts (par. 4-23).
(7) Connect fuel tank-to-fuel shutoff valve hose (16) to valve
connector (25).
(8) Position frame tube (1) to outer frame (6), add shim
washers (2) as required to maintain a gap of 1/2 washer thickness
between both ends of tube and frame.
(9) Secure tube to frame with four washers (20) and two screws
(19).
(10) Position lifting bracket (18) to frame, and add shim
washers (2) as required to maintain a gap of one washer between brac-
ket and frame at both ends of bracket.
(11) Secure lifting bracket to frame with two spacers (5),
washers (4), and screws (3).
5-12
