TM 5-6115-596-14
ENGINE MAINTENANCE PROCEDURES
Section V.
5-9.
General,
This section contains instructions for removal, installation, and
Also covered in this
inspection after installation of the engine.
section is the installation of the engine belt drive sheave and ad-
apter.
5-10.
Engine (fig. 5-l).
a.
Removal.
(1) Make certain all power is turned OFF.
(2) Close fuel shutoff valve (par. 2-5).
(3) Disconnect spring (17) from lifting bracket (18).
(4) Remove two screws (3), spacers (5), and washers (4), and
remove lifting bracket and washers (2) from outer frame (6).
(5) Remove two screws (19) and four washers (20), and remove
frame tube (1) and washers (2) from frame.
(6) Disconnect fuel tank-to-fuel shutoff valve hose (16) at
valve connector (25).
(7) Remove starter-generator drive belts (par. 4-22).
(8) Remove screw (22) and two washers (23) securing drive belt
brace (15) to starter-generator (24).
(9) Remove mufflers (par. 4-20).
(10) Loosen screw (7), and move bracket (21) away from rear
exhaust manifold (8).
(11) Remove 6 screws (9) and 12 washers (10), and remove engine
(11) from inner frame (12).
(12) If replacement engine is to be installed, remove:
(a) Fuel filter-to-fuel pump hose (par. 4-18).
(b) Fuel filter with shutoff valve (par. 4-17).
5-9
