TM 5-6115-596-14
Legend for figure 4-12.
9 - Rheostat spacer
1 - Engine start switch
hex nut
10 - Voltage control rheostat
2 - Plate rivet
11 - Relay and housing assembly
3 - Switch identification
12 - Relay flat washer
plate
13 - Relay lockwasher
4 - Relay and ground lead
screw
14 - Relay and ground lead nut
5 - Rheostat screw
15 - Engine start switch
6 - Rheostat lockwasher
16 - Switch nut
7 - Rheostat flat washer
17 - Switch washer
8 - Panel
Position relay and housing assembly (11) to panel and secure
c.
with flat washer (12), lockwasher (13), screw (4), and nut (14).
Installation (fig. 4-11 or 4-11.1).
4-31.
a.
Position control panel (5) to outer frame (11) and secure
with three washers (10) and screws (9).
Connect regulator ground lead (21) to relay and housing
b.
assembly (2) and secure with screw (3) two washers (13), and nut (12).
c.
Connect leads (18) to engine start switch (6).
d.
Connect circuit 950 lead (8) and circuit 950A lead (20) to
(Generator Set, serial numbers 923-001
rheostat connectors (7).
thru 923-553).
Position power receptacle (4) to control panel and secure with
e.
eight washers (17), four screws (15), and nuts (16).
f.
relay.
Connect relay-to-start switch lead (14) and relay-to-regulator
g.
battery connector lead (1) to relay.
4-32.2
Change 2
