TM 5-6115-405-15
1
Screw
25
Weight
49
Washer
2
Washer
26
Arm
50
Extension
3
Washer
27
Cup
51
Element
4
Rotor
28
Spring
52
Shaft
5
Screw
29
Washer
53
Line Ay
6
Screw
30
Ring
54
Line
7
Washer
31
Seal
55
Line
8
Junction box
32
Screw
56
Screw
9
Connector
33
Bearing
57
Nut
10
Screw
34
Gasket
58
Valve
11
Strap
35
Screw
59
Screw
12
Grommet
36
Washer
60
Nut
13
Screw
37
Grip
61
Washer
14
Washer
38
Screw
62
Bracket
15
Washer'
39
Guard
63
Screw
16
Stator
40
Bracket
64
Washer
17
Plate Ay
41
Screw
65
Washer
18
Bearing
42
Washer
66
Washer
19
Key
43
Screw
67
Screw
20
Shaft
44
Washer
68
Nut
21
Back Plate
45
Connector
69
Spring
22
Pin
46
Cam & Shaft
70
Skid
23
Pin
47
Guide
71
Drive Case
24
Screw
48
Link
Figure 6-2 -- Continued.
Section III. CARBURETOR CHAMBER
6-9. General
a. Using new screws (27, fig. 6-3), install reed
This section contains complete repair instructions for
(30), reed spring (29), and reed stop (28) on carburetor
the carburetor chamber (but not for the carburetor
chamber subassembly (25).
assembly which is covered in Section V).
Tool
applications and special procedures are provided where
Note
applicable.
Be sure there are no chips and burrs
on the chamber surface.
6-10. Disassembly
Figure 6-3 is a complete exploded view of the
b. Using screws (24), secure carburetor chamber
carburetor chamber section.
Disassemble in the
subassembly (25) to the engine.
numerical sequence indicated on figure 6-3. Note the
c. Install rubber grommet (26) and insert the fuel
special procedures provided in paragraph 5-4.
line through the grommet.
d. Place cover bracket assembly (9) in p1osition in
6-11. Inspection and Repair
front of carburetor assembly (20), and insert two screws
a. Inspect all parts for visible damage.
(7) and lock washers (8) through the bracket and
b. Inspect reed (30, fig. 6-3) to be sure it is not
carburetor assembly.
cracked, warped, or ragged.
e. Position two carburetor gaskets (21) on either
c. Inspect the surface of carburetor chamber
side of heat dam (22) behind carburetor assembly (20)
subassembly (25) on which the reed seats. There must
and make sure screws go through proper holes in
be no gouges or wear indicated. It is recommended that
gaskets.
screws (27) be discarded and new ones used for
f. Angle carburetor assembly and attached parts
assembly.
as necessary and place in position in carburetor
chamber subassembly (25). Connect fuel line to inlet
6-12. Reassembly
fitting.
Reassemble parts in reverse of numerical sequence
as illustrated on figure 6-3. Note the following.
6-7