TM 5-6115-405-15
e. Position leads as necessary and secure with
a. If engine parts (sec. IV) are to be disassembled,
cable clamp (11).
do not assemble generator' until engine is completely
reassembled.
Note that instructions for installing
f. Secure junction box and stator mounting plate
crankcase gasket (35, fig. 6-2) and screws (33) are
with remaining (right-hand side) screws (5).
provided in paragraph 6-16.
g. Aline keyway in generator rotor (4) with keyway
b. Apply a small amount of grease to needle
in generator shaft (21), and install rotor. Insert machine
bearing (19). Use fabricated bearing and seal tool to
key (20) from the outside to simplify assembly.
install needle bearing (19) in stator mounting plate (18).
h. When reconnecting new fuel lines only, it is
c. If generator stator (16) was replaced, thread the
necessary to heat the ends of the lines in a pot of boiling
leads through rubber grommet (17) in stator mounting
water until they are soft. They can then be easily
plate (18), and through rubber grommet (12) in
stretched over the fittings of fuel tank selector valve
drivecase (75). Be careful not to pinch the leads; secure
(62).
the stator mounting plate with left-hand side screws (5).
d. Connect stator leads to output connector (9) and
secure output connector to junction box (8).
6-5
