TM 5-6115-405-15
1
Captive nut
11
Choke button
21
Carburetor gasket (2)
2
Air cleaner element cover
12
Rubber grommet
22
Heat dam
3
Air cleaner element
13
Cotter pin
23
Cotter pin
4
Retaining ring
14
Choke rod
24
Screw, hex-hd
5
Instruction plate
15
Throttle return spring
25
Carburetor chamber subassembly
6
Gasket
16
Screw, pan-hd
26
Rubber grommet
7
Screw, hex-hd
17
Throttle return spring clamp
27
Screw, pan-hd
8
Washer, lock
18
Rubber grommet
28
Reed stop
9
Cover bracket assembly
19
Rubber plug
29
Reed spring
10
Felt plug
20
Carburetor assembly
30
Reed
Figure 6-3 - continued.
i. Connect throttle return spring (15) to the clamp
Note
and to the second hole from the unflanged end of
Only if a new fuel line is installed, is
carburetor throttle lever as shown on figure 6-3.
it necessary to heat the end of the
j. Install rubber grommet (12) and insert choke rod
line in a pot of boiling water until it is
(14) through the grommet. Slide the choke rod through
soft.
hole in choke lever and secure with cotter pin (13).
k. Install the throttle shaft extension with the
concave-cut side of the flat end up. Push throttle shaft
g. Check that carburetor gaskets are properly
extension on until the notch engages the roll pin.
positioned, and tighten two screws (7).
Secure the linkage as shown in figure 3-5.
h. If throttle return spring clamp (17) was removed,
install with screws (16). Use the impressions made in
the clamp as a guide to position the part.
6-9