TM 5-6115-275-14
NAVFAC P-8-615-14
TO 35C2-3-452-1
CHAPTER 5
INTERMEDIATE (FIELD) (DIRECT SUPPORT AND GENERAL SUPPORT) AND DEPOT MAINTENANCE
INSTRUCTIONS
Section I. REPAIR PARTS, SPECIAL TOOLS AND EQUIPMENT
5-1.
Special Tools and Equipment
There are no special tools or equipment required by
Direct
and
General
Support
Maintenance
to
Repair/Overhaul the generator set.
NOTE
Air
Force
users
may
perform
maintenance within the scope of their
capability.
5-2.
Direct and General Support Maintenance
Repair Parts
Direct and general support maintenance repair parts
are listed and illustrated in TM 5-61 15-275-24P, or TO
35C2-3-452-1.
Section II. TROUBLESHOOTING
5-3.
General
a.
This
section
contains
troubleshooting
information for locating and correcting most of the DS
and GS troubles which may develop in the generator set.
Each malfunction for an individual component, unit or
system is followed by a list of tests or inspections which
will help you to determine the probable causes and
corrective actions to take. You should perform the
tests/inspection and corrective actions in the order listed.
b.
This manual cannot list all malfunctions that
may occur, nor all tests or inspections and corrective
actions. If a malfunction is not listed or is not corrected
by listed corrective actions, notify your supervisor.
5-4.
Troubleshooting
a.
Before you use this table, consult table 4-1,
Organizational Troubleshooting, and be sure you have
performed all applicable checks.
b.
Refer
to
table
5-1
for
intermediate
troubleshooting.
Change 8 5-1