TM 5-6115-275-14
NAVFAC P-8-615-14
TO 35C2-3-452-1
4-46.
Electrical Leads
a.
Removal.
NOTE
ectrical
leads
which
can
be
replaced
by
organizational maintenance are the
short jumper leads connecting the
controls and instruments on the back
of the control box door.
Refer to figures 4-61 or 4-62 and remove the leads
as necessary.
b.
Cleaning, Inspection and Repair.
(1)
Clean the electrical leads with a
clean, dry cloth.
(2)
Inspect
for
insulation
cracks,
breaks,
and
for
defective
terminals. Repair or replace all
damaged or defective leads.
c.
Installation. Refer to figures 4-61 or 4-62 and
install the leads.
4-47.
Terminal Block (Model MEP-023A)
a.
Removal. Refer to figure 4-71 and remove
the terminal block.
b.
Cleaning, Inspection and Repair.
(1)
Clean the terminal block with a
clean dry cloth.
(2)
Inspect the terminal block for
cracks, breaks and other damage.
Replace if damaged or defective.
c.
Installation. Refer to figure 4-71 and install
the terminal block.
Figure 4-71. Terminal block, removal and installation (Model MEP-023A).
Section XII. MAINTENANCE OF THE GENERATOR ASSEMBLY
4-48.
General
The generator is attached to the engine by a
coupling on the rotor shaft which
connects
to
the
drive
hub
mounted on the engine flywheel.
Disconnection of the coupling
from
the
drive
hub
permits
removal of the generator as a
unit.
Change 2 4-82
