TM 5-6115-275-14 NAVFAC P-8-615-14 TO 35C2-3-452-1 c. Cleaning, Inspection and Repair. WARNING Clean   all   parts   in   a   well-ventilated area.        Avoid    inhalation    of    solvent fumes    and    prolonged    exposure    of skin    to    cleaning    solvent.         Wash exposed skin thoroughly. Dry cleaning solvent (Fed.  Spec.  P-D-680 and  P-S-661)  used  to  clean  parts  is potentially   dangerous   to    personnel and  property.    Do  not  use  near  open flame  or  excessive  heat.    Flash  point of solvent is 100° F(38°C). (1) Clean    items    with    cleaning    solvent. Fed.  Spec.    P-D-680  or  P-S-661,  and dry thoroughly. (2) Inspect   all   parts   for   cracks,   breaks, stripped threads or other damage. (3) Replace a damaged or defective part. d. Installation   (All   Serial   Numbers   except MA68-0001 thru MAf68-2987. (1) Install the three-way valve, heater fuel valve and brackets, figure 4-53). (2) Install   the   fuel   hose   and   fuel   lines, paragraph 4 22. e. Installation (Serial Number Range MA680001 thru MA68-2987. (1) Install    the    three-way    valve,    heater valve, and brackets.  figure 4-54. (2) Install     the fuel hose and lines. paragraph 4-22. 4-25. Fuel Selector Valve (Model MEP-023A) a. Removal.  Refer to figure 4-52 and remove the fuel selector valve. b. Cleaning, Inspection and Repair. WARNING Clean   all   parts   in   a   well-ventilated area.        Avoid    inhalation    of    solvent fumes    and    prolonged    exposure    of skin    to    cleaning    solvent.         Wash exposed skin thoroughly. Dry cleaning solvent (Fed.  Spec.  P-D-680 and  P-S-661)  used  to  clean  parts  is potentially   dangerous   to    personnel and  property.    Do  not  use  near  open flame  or  excessive  heat.    Flash  point of solvent is 100° F(38'C). (1) Clean item with cleaning solvent, Fed. Spec.    P-D-680  or  P-S-661   and   dry thoroughly. (2) Inspect  the  valve  for  cracks,  breaks, and improper operation. (3) Replace    all    damaged    or    defective parts. c. Installation.  Refer to figure 4-52 and install the fuel selector valve. 4-26. Fuel    Tank    Bracket    and    Strap    Assemblies (Model MEP-018A) a. Removal. (1) Remove the fuel tank (par.  4-21). (2) Remove   the   fuel   tank   bracket   and strap assemblies as shown by figure 4- 55. 4-64