TM 5-6115-275-14
NAVFAC P-8-615-14
TO 35C2-3-452-1
b.
Cleaning, Inspection and Repair.
WARNING
Clean all parts in a well-ventilated
area. Avoid inhalation of solvent
fumes and prolonged exposure of
skin to cleaning solvent. Wash
exposed
skin
thoroughly.
Dry
cleaning solvent (Fed. Spec. P-D-680
and P-S-661) used to clean parts is
potentially dangerous to personnel
and property. Do not use near open
flame or excessive heat. Flash point
of solvent is 100° F(38'C).
(1)
Clean brackets, straps, guard and
hardware
with
cleaning
solvent,
Federal Specification P-D-680 or P-S-
661, and dry thoroughly.
(2)
Clean all rust and scale from the
muffler with a wire brush.
(3)
Inspect the muffler, brackets and
guard for cracks, breaks, and other
damage. Replace all damaged or
defective parts.
c.
Installation.
(1)
Install the muffler and muffler guard,
Model MEP-018A, figure 4-44.
(2)
Install the muffler and brackets, Model
MEP-023A, figure 4-45.
4-20.
Oil Drain Valve and Fittings
a.
Removal. Refer to figure 4-46 and remove
the oil drain valve and fittings.
b.
Cleaning, Inspection and Repair.
WARNING
Clean all parts in a well-ventilated
area. Avoid inhalation of solvent
fumes and prolonged exposure of
skin to cleaning solvent. Wash
exposed
skin
thoroughly.
Dry
cleaning solvent (Fed. Spec. P-D-680
and P-S-661) used to clean parts is
potentially dangerous to personnel
and property. Do not use near open
flame or excessive heat. Flash point
of solvent is 100° F(38°C).
(1)
Clean items with cleaning solvent, Fed.
Spec. P-D-680’ or P-S-661, and dry
thoroughly
with
low
pressure
compressed air.
(2)
Inspect all parts for cracks, breaks,
and distorted threads. Replace all
damaged parts.
c.
Installation. Refer to figure 4-46 and install
the oil drain valve and fittings.
Figure 4-46. Oil drain valve, removal and installation.
4-54
