TM 5-6115-596-14
(1) If insulating compound on outer surface of coils is dry,
cracked, or chipped, apply coat of insulating varnish and dry until
tacky.
(2) Add as many additional coats as necessary to protect surface,
Dry each coat until tacky before applying next coat.
(3) Place housing assembly or armature in over and bake for 2
hours at 193F (89.5C).
(4) After baking armature or housing assembly, perform test
series outlined in paragraphs 5-22b or 5-22e.
Assembly (fig. 5-7).
5-24.
NOTE
Make certain scribe marks, placed
on components at disassembly, aline
when assembling fan cover (25),
bearing and brush support (18),
brush cover band (15), and generator
housing (14),
Position armature baffle (49) and bearing (50) to shaft of
a.
armature (28), and press bearing on shaft.
Install snap ring (38) on shaft of armature.
b.
Position commutator-end ball bearing (26) to bearing and brush
c.
support (18), and press bearing in support.
Position 6 brush holders (39) with 12 tubes (40) to support
d.
and secure with 12 insulating washers (41), flat washers (42), and
nuts (43).
Position support baffle (27) and support to armature, and
e.
install key (48).
5-37
