TM 5-6115-332-14
P-8-614-14
TO 35C2-3-424-1
b. Installation.
(1) Attach a sling to the engine lifting eye and with
the aid of a suitable hoist, lower engine into position
on mounting bracket. Secure with screw, flat washer,
lockwasher and nut.
(2) Connect the engine control cable to the rear of
the engine.
(3) Connect the fuel hoses and starter cables.
(4) Position adapter in place on the flywheel and
secure with lock and screws.
NOTE
Bend tang up over screws.
(5) Position the drive disk in place on the adapter
and secure with locks and screws.
NOTE
Bend tang up over screws.
(6) Place air inlet grille around the generator hous-
ing and secure housing and grille to the flywheel hous-
ing with lockwashers and screws.
NOTE
Torque screws to 13 to 16 FT. LB. (1.80 to 2.21
kgm).
(7) Install the ground strap.
(8) Position blower fan in place and secure with
washers and screw.
NOTE
Torque screws to 14 to 16 FT. LB. (1.94 to 2.21
kgm).
(9) Install the fan cover to the generator housing
with washers and screws.
(10) Reconnect electrical cable to generator.
(11) Position the control box in place on the bot-
tom resilient mounts and secure with washers and
screws.
(12) Secure the control box to the generator hous-
ing with washers and screws.
(13) Install ground strap.
(14) Reconnect electrical cables to control box.
(15) Position the control box bracket in place and
secure to the top of the generator housing with
washers and screws.
(16) Install lifting eye.
(17) Secure bracket to side of the generator hous-
ing with washers and screws.
(18) Install resilient mounts to control box
bracket with screws, washers, and nuts.
(19) Place toolbox in position and secure with
screws, lockwashers, and nuts.
(20) Place guard frame over generator set and
secure to the flywheel housing with screw,
lockwashers, and nuts.
(21) Secure guard frame to the skid base using
screws, lockwashers, and nuts.
(22) Place battery in battery frame and position
hook bolt in place.
(23) Install upper battery frame with washers and
nuts.
(24) Install battery terminal covers on both bat-
tery terminals. Reconnect battery cables.
(25) Place fuel can in fuel can bracket and secure
with strap. Depress clamp to secure.
(26) Place fuel can adapter in fuel can and secure
by depressing the locking handle.
(27) Ensure replacement of drain cock. Add oil as
required.
6-12
Change 7