TS 022252
TM 5-6115-329-14
TO 35C2-3-440-1
NOTE
The Simpson 160 is only available in new shop sets
as a substitute for the TS-352B/U or AN/URM-105.
b. Using the Ohms Scale. The ohms scale is
used to make tests for continuity, shorts and re-
sistance.
(1) “Zeroing” the Meter (Fig. 4-10). The
multimeter must be set up and “zeroed” before
making these tests. Do the following steps that
match the multimeter.
NOTE
If the needle will not “zero”, replace the batteries. If
the needle still will not “zero” after replacing the
batteries, turn the meter in for repair.
Figure 4-10.
“Zeroing” the multimeter (sheet 1 of 3).
4 - 1
6
