TM 5-6115-275-14 NAVFAC P-8-615-14 TO 35C2-3-452-1 (5) Refer  to  figure  8-21  and  remove  the  fuel drum adapter clips. Figure 8-21.  Fuel drum adapter lips, removal and installation. (6) Remove the control cabinet assembly, paragraph 6-1. (7) Remove   the   engine   and   generator, paragraph 6-2. (8) Remove the engine drip pan, paragraph 8-3. b. Cleaning, Inspection, and Repair. WARNING Clean   all   parts   in   a   well-ventilated area.        Avoid    inhalation    of    solvent fumes    and    prolonged    exposure    of skin    to    cleaning    solvent.         Wash exposed skin thoroughly. Dry cleaning solvent (Fed.    Spec.    P-D-680    and    P-S-661) used    to    clean    parts    is    potentially dangerous to personnel and property. Do    not    use    near    open    flame    or excessive heat. Flash point of solvent is 100F(38°C). (1) Clean items with cleaning solvent, Fed. Spec P-D-680 or P-S-661, and dry thoroughly. (2) Inspect for damage and defects.  Weld cracks or  breaks  and  straighten  dents.    Replace  a  skid base that is damaged beyond repair. c. Installation. (1) Install  the  engine  drip  pan,  paragraph 8-3. (2) Install the engine and generator, para- graph 6-2. (3) Install   the   control   cabinet   assembly, paragraph 6-1. (4) Install the fuel drum adapter clip, figure 8-21. (5) Install the grounding stud, figure 8-20. (6) Install  the  electrical  receptacle,  figure 8-19. (7) Install the fuel tank, bracket, and strap, figures 8-17 and 8-18. (8) Install  the  fuel  filter,  hoses,  lines,  and valve  as  necessary.    Refer  to  figures  8-13,  8-14,  8-15, and 8-16. 8-5. Engine  Support,  Drip  Pan,  Deflector  Plates, and Baffle Plates (Model MEP-023A) a. Removal (1) Remove   the   engine   and   generator, paragraph 6-2. (2) Refer  to  figure  8-22  and  remove  the engine   support,   drip   pan,   deflector   plates   and   baffle plates. 8-28