TM 5-6115-434-12 (3) Installation.  Install in reverse order of removal procedures. e. Push Button Switch (S28, S24). (1) Removal.  Tag and disconnect electrical connections to switch.  Remove nut and washer attaching switch to panel.  Remove switch and seal from panel. (2) Cleaning and inspection. (a) Clean switch with filtered compressed air or wipe with a clean rag lightly moistened with an approved cleaning solvent. (3) Installation.  Install in reverse order of removal instructions. f. Switch (S5). (1) Removal.  Tag and disconnect electrical connections to switch.  Remove nut and washer attaching switch and switch guard to panel.  Remove switch, switch guard and boot from panel. (2) Cleaning and inspection. (a) Clean switch with filtered compressed air or wipe with a clean rag lightly moistened with an approved cleaning solvent. (b) Visually inspect switch for corrosion, cracks, damaged threads or other evidence of damage. (3) Installation.  Install switch in reverse order of removal procedures. g. Rotary Switch (S25, .S26). (1) Removal.  Tag and disconnect electrical connections to switch.  Loosen set screw in switch knob.  Remove knob from switch.  Remove four screws, eight washers from switch. Remove switch and grommet from panel. (2) Cleaning and inspection. (a) Clean  switch  with  filtered  compressed  air  and  electricians  brush  or  clean  switch  with  an  approved cleaning solvent and electricians brush. (b) Visually  inspect  switch  for  corrosion,  cracks,  damaged  threads,  proper  alignment  of  contacts  and other evidence of damage. (3) Installation.  Install switch in reverse order of removal procedures. h. Rotary Switch (S14, S15, .S16, SS1), (1) Removal.  Tag and disconnect electrical connections to switch.  Loosen set screw in switch knob.  Remove knob from switch.  Remove nut and washer attaching switch to panel. Remove switch and shaft seal from panel. (2) Cleaning and inspection (a) Clean switch with filtered compressed air and electricians brush or clean with an approved cleaning solvent and electricians brush. (b) Visually  inspect  switch  for  corrosion,  cracks,  damaged  threads,  proper  alignment  of  contacts  and other evidence of damage. (3) Installation.  Install switch in reverse order of removal procedures. i. Circuit Breaker (CB5, CB11, CB12, CB 2). (1) Removal.  Tag and disconnect electrical connections to circuit breaker.  Remove nut and washer attaching circuit breaker to panel. Remove circuit breaker and seal from panel. (2) Cleaning and inspection. (a) Clean circuit breaker with filtered compressed air or wipe with a clean rag lightly moistened with an approved cleaning solvent. (b) Visually inspect circuit breaker for corrosion, cracks, damaged threads or other evidence of damage. (3) Installation. Install in reverse order of removal procedures. j. Circuit Breaker (CB1, CB2, CB9). (1) Removal.  Tag and disconnect electrical connections to circuit breaker.  Remove circuit breaker and boot from panel. (2) Cleaning and inspection. (a) Clean circuit breaker with filtered compressed air or wipe with a clean rag lightly moistened with an approved cleaning solvent. (b) Visually inspect circuit breaker for corrosion, cracks, damaged threads or other evidence of damage. (3) Installation.  Install in reverse order of removal procedures. 3-56.  Conditioned Air System Circuit Breaker Panel (fig. 3-17) Warning Electrical power shall be shut off prior to maintenance on electrical components Note Access to the conditioned air system circuit breaker panel is obtained by removing two bolts and two washers from each end of the panel and extending panel outward on its electrical harness 3-60