TM 5-6115-434-12
CHAPTER 3
OPERATOR AND ORGANIZATIONAL MAINTENANCE
INSTRUCTIONS
Section I. OPERATOR'S AND ORGANIZATIONAL MAINTENANCE
REPAIR PARTS, TOOLS, AND EQUIPMENT
3-1. Tools and Equipment
a.
Basic issue tools and repair parts issued with or authorized for the power unit are listed in the Basic Issue Items
List, appendix B of this manual.
b.
The special tools and equipment required to perform operator's and organizational maintenance on the power
unit are listed in table 3-1 and appendix B. References and illustrations indicating the use of these tools and equipment
are listed in the table. The five-digit number preceding the stock number is the Federal supply code number for the
manufacturer of the tools and equipment. No special tools or equipment are required by operator for performing
maintenance on the power unit. All maintenance on the power unit is accomplished by organizational maintenance
personnel.
3-2. Organizational Maintenance Repair Parts
Organizational maintenance repair parts are listed and illustrated in TM 5-6115-434-20P (When printed).
Section II. LUBRICATION
3-3. General Lubrication Information
a.
This section contains lubrication instructions which are supplemental to, and not specifically covered in the
lubrication order.
b.
The lubrication order is an exact reproduction of the approved lubrication order. Refer to LO 5-6115-434-12.
Table 3-1. Special Tools and Equipment
FSN (If applicable)
Item
or part no.
Para No.
Use
Screwdriver and wrench
5120-668-6122
3-8
Adjustment of fuel control governor
assembly
and acceleration limiter valve.
Analyzer: gas turbine
4920-778-6091
3-8
Check and adjustment of engine opera-
engine
tion and components.
Cable: branched electri-
(99193) 284692-1-1
3-8
Connect analyzer to gas turbine engine
cal special purpose
Sling: multiple leg
(99193) 284698-1-1
2-4
Hoisting power unit.
Figure 3-1. Not used.
3-4. Detailed Lubrication Information
a.
General. Keep all lubricants in closed containers and store in clean, dry place away from extreme heat. Allow
no dust, dirt, or other foreign material to mix with lubricants. Keep all lubrication equipment clean and ready to use.
Clean lubrication equipment before and after use.
3-1
