TM
5-6115-329-25P
INTRODUCTION
( 1 ) Source code indicates the selection status
1.
Scope
a n d source for the listed item. Source codes used
This manual lists repair parts required for the
are:
performance
of
organizational,
direct
support,
Code
Explanation
general support, and depot maintenance of the
P
Repair parts which are stocked in or sup-
plied from the GSA/DSA, or Army
supply system and authorized for use at
2.
General
indicated maintenance categories.
M
Repair parts which are not procured or
T h i s Repair Parts List is divided into the follow-
stocked, but are to be manufactured in
ing
sections:
indicated maintenance levels.
A s s e m b l i e s which are not procured or
a. P r e s c r i b e d
Load
Allowance
A
stocked as such, but are made up of two
composite
listing
of
repair
parts
having
or more units. Such component units
q u a n t i t a t i v e allowances for initial stockage at the
carry individual stock numbers and de-
organizational
level.
scriptions, are p r o c u r e d and stocked
separately and can be assembled to form
the required assembly at indicated main-
parts authorized for the performance of mainte-
tenance categories.
Parts and assemblies which are not pro-
X
item number sequence.
cured or stocked and the mortality of
which normally is below that of the ap-
c . Special Tools, Test and Support Equipment--
p l i c a b l e end item or component. The
S e c t i o n IV. ( N o t a p p l i c a b l e . )
failure of such part or assembly should
result in retirement of the end item from
the supply system.
parts authorized for the performance of mainte-
Repair parts which are not procured or
Xl
n a n c e at the direct support, general support, and
stocked. The requirement of such items
d e p o t level in figure and item number sequence.
will be filled by use of the next higher
assembly or component.
e. Special Tools, Test and Support Equipment-
Repair parts which are not stocked. The
X2
Section VI. (Not
applicable.)
indicated maintenance category requiring
f. Federal Stock Number and Reference Num-
such repair parts will attempt to obtain
Where
them through cannibalization.
ber Index--Section VII. A list of Federal
stock
s u c h repair parts are not obtainable
numbers in ascending numerical sequence, fol-
requirements
cannibalization,
through
l o w e d by a list of reference numbers appearing in
will be requisitioned, with accompanying
all of the listings, in alpha-numeric sequence,
j u s t i f i c a t i o n , through normal S u p p l y
c r o s s - r e f e r e n c e d to the illustration figure number
channels.
and item number.
Major assemblies that are procured with
G
PEMA funds for initial issue only as
Note. Items not illustrated are cross-referenced to
exchange assemblies at DSU and GSU
assembly group number.
level.
T h e s e assemblies will not be
stocked above GS and DS level or re-
3.
Explanation
of
Columns
turned to depot supply level.
T h e following provides an explanation of columns
(2) Maintenance code indicates the lowest
c a t e g o r y of maintenance authorized to install the
a. Source, Maintenance, and Recoverability
l i s t e d item. The maintenance codes are:
Codes
(SMR).
Explanation
Code
Organizational maintenance
O
Note. Common hardware items known to be readily
Direct support maintenance
F
available in Army supply channels are assigned Mainte-
General support maintenance
H
nance codes only. Source codes, Recoverability codes, and
Maintenance Allowances are not assigned this category.
Depot maintenance
D