TM 5-6115-320-20P
SECTION I
INTRODUCTION
1. Scope
Code
Explanation
This manual lists repair parts and special tools required
for the performance of organizational maintenance of
P Applied to repair parts which are stocked in or
the generator set.
supplied from DSA/GSA or Army supply system,
and authorized for use at indicated maintenance
2. General
categories.
a. The Repair Parts List is arranged as follows:
M Applied to repair parts which are not procured or
stocked but are to be manufactured at indicated
(1) Individual parts and major assemblies are
maintenance categories.
listed alphabetically by item name within the numbered
functional groups.
A Applied to assemblies which are not procured or
stocked as such but are made up two or more
(2) Assembly
components
and
units, each of which carry individual stock
subassemblies are indented and listed alphabetically by
numbers and descriptions and are procured and
item name under major assemblies.
stocked and can be assembled by units at
b. This Repair Parts and Special Tools List is
indicated maintenance categories.
divided into the following sections:
X
Applied to parts and assemblies which are not
(1) Prescribed Load Allowance (PLA)Section
procured or stocked, the mortality of which is
normally below that of the applicable end item,
allocated for initial stockage at the organizational level.
and the failure of which should result in
This is a mandatory stockage allowance.
retirement of the end item from the, supply
(2) Special Tools, Test and Support
system.
Equipment-Section III. A list of special tools, test and
X1 Applied to repair parts which are not procured or
support equipment authorized for the performance of
stocked, the requirement for which will be
maintenance at the organizational level (Not
supplied by use of the next higher assembly or
Applicable).
components.
(3) Repair Parts-Section IV. A list of repair
X2 Applied to repair parts which are not stocked.
parts authorized for the performance of maintenance at
The indicated maintenance category requiring
the organizational level.
such repair parts will attempt to obtain them
(4) Federal Stock Number and Reference
through cannibalization; if not obtainable
through cannibalization, such repair parts will be
numbers followed by reference numbers in ascending
requisitioned with supporting justification
alpha-numeric sequence, cross-referenced to index
through normal supply channels.
number.
C Applied to repair parts authorized for local
procurements. If not obtainable from local
3. Explanation of Columns
procurement, such repair parts will be
The following provides an explanation of columns in the
requisitioned through normal supply channels
tabular lists in Sections II, III, and IV:
with a supporting statement of non-availability
from local procurement.
a. Source, Maintenance and Recoverability Codes
G Applied to major assemblies that are .procured
(SMR):
with PEMA (Procurement Equipment Missile
Army) funds for initial is sue only to be used as
(1) Source Code, indicates the selection
status and source for the listed item. Source codes are:
iii
