LO 5-6115-598-12
-KEY-
Mixing lube oils MIL-L-23699 and MIL-L-7808 will damage the equip-
ment. Always check the log book before adding oil to ensure that you
add the same type of oil as is in the engine. If you switch from one type
of oil to the other when changing the engine oil, flush the lubrication
system by performing the actions in NOTE 5 below.
6. LUBRICANTS. The following is a list of lubri-
NOTES:
cants with the NATO CODES and applicable
specification numbers.
1. FOR OPERATION OF EQUIPMENT IN PRO-
TRACTED COLD TEMPERATURES BELOW -25F
NATO CODE 0-148
NATO CODE 0-156
(-32C). Relubricate with lubricant specified in the
MIL-L-7808
MIL-L-23699
key for temperatures below -25o F (-320C).
Copy of this Lubrication Order will remain with
2. OIL CAN POINTS. Every 100 hours clean and
the equipment at all times. Instructions
lightly coat door hinges, latches, and all exposed
contained herein are mandatory.
adjusting threads with oil.
By Order of the Secretary of the Army:
3. OIL FILTER. After installing new filter element,
CARL E. VUONO
fill crankcase, operate engine 5 minutes and check
General, United States Army
for leaks. Stop engine; check crankcase oil level and
Chief of Staff
bring to full mark.
Official:
Oil filter replacement shall align with oil change
requirements.
WILLIAM J. MEEHAN, II
Brigadier General, United States Army
4. ENGINE. Check oil level with engine in a static
The Adjutant General
condition.
NOTE
DISTRIBUTION:
in Note
5
only
Perform
the actions
T O be distributed in accordance with DA Form
one t y p e o f
if
you
switched from
12-25A, Operator and Unit Maintenance
changing
when
lube
another
oil
to
Requirements for Generator Set, Gas Turbine
the engine oil.
Engine Driven, Tactical Skid Mounted, 150 KW
400 Hertz, Alternating Current:
5. FLUSHING THE LUBRICATION SYSTEM.
After changing the oil and filters, operate engine
or 30 minutes. Stop engine and change oil and
filters.
CARD 2 OF 2
LO 5-6115-598-12
U.S. GOVERNMENT PRINTING OFFICE : 1994 300-721 (00301)
PIN: 051656-000
