Cleaning and Inspection.
Clean all parts in a well-ventilated
area. Avoid inhalation of solvent
fumes and prolonged exposure of
skin to cleaning solvent. Wash
cleaning solvent (Fed. Spec. P-D-680
and P-S-661) used to clean parts is
potentially dangerous to personnel
and property. Do not use near open
flame or excessive heat. Flash point
of solvent is 100° F(38°C).
Clean housing with cleaning solvent,
Fed. Spec. P-D-680 or P-S-661,GI and dry thoroughly.
Inspect for damaged
hardware and replace defective or missing parts as
Installation. Refer to figure 6-3 or 6-4 and
install the generator and engine on the applicable model