Cleaning and Inspection.
Clean all parts in a well-ventilated
area. Avoid inhalation of solvent
fumes and prolonged exposure of
skin to cleaning solvent. Wash
cleaning solvent (Fed. Spec. P-D-680
and P-S-661) used to clean parts is
potentially dangerous to personnel
and property. Do not use near open
flame or excessive heat. Flash point
of solvent is 100° F(38°C).
Clean items with cleaning solvent, Fed.
Spec. P-D-680 or P-S-661, and dry thoroughly.
Inspect for damage and defects and
replace defective or missing parts as necessary.
Installation. Refer to figure 6-1 or 6-2 and
install control box on applicable model generator set.
Generator and Engine
engine may be removed as a single
unit or may be disconnected and
engine must be removed as a single
unit since removal of the generator
from the engine requires disassembly
of the generator.
Refer to figure 6-3 or 6-4 and remove
generator and engine from the applicable model