Figure 4-55. Fuel tank bracket and strap assemblies. removal and installation (Model MEP-018A).
Cleaning, Inspection and Repair.
Clean all parts in a well-ventilated
area. Avoid inhalation of solvent
fumes and prolonged exposure of
skin to cleaning solvent. Wash
cleaning solvent (Fed. Spec. P-D.680
and P-S-661) used to clean parts is
potentially dangerous to personnel
and property. Do not use near open
flame or excessive heat. Flash point
of solvent is 100° F(38°C).
Clean metal items with cleaning
solvent, Fed. Spec. P-D-680 or P-S-
661 and dry thoroughly.
Clean the webbing with clean, warm
water and detergent.
Inspect all metal parts for cracks,
breaks, or other damage. Replace all
Inspect the webbing for cuts, fraying,
Installation. Refer to figure 4-56 and install
the fuel container hold-down assembly and
Figure 4-56. Fuel tank brackets. and hold-down
assembly, removal and installation (Model MEP-023A)